at some point, Qtractor writes it somewhere. So I must be able to populate this list myself somehow, programatically?
on the a. case, talking about native .synthv1 preset files, that's not and never were a qtractor job whatsoever--it is synthv1 actually who does it on its own way. you should know that, once you load a preset file from the main synthv1 GUI it stays there mapped on drop-down list from that moment on. again, it doesn't matter if you're on the LV2 plugin version or the JACK stand-alone client, they both refer to the same configuration file that is ~/.config/rncbc.org/synthv1.conf
.
of course, if you dare and are brave enough, you can try editing the preset map section that is stored in the .conf file. at your own risk and benefit. ;)
cheers
Copyright (C) 2006-2024 rncbc aka Rui Nuno Capela. All rights reserved.
Powered by Drupal
Recent comments
1 day 7 hours ago
1 day 16 hours ago
2 days 11 hours ago
2 days 12 hours ago
2 days 12 hours ago
2 days 12 hours ago
2 days 12 hours ago
2 days 13 hours ago
2 days 14 hours ago
2 days 14 hours ago