terminal hardware devices are always split to their inputs and output sides, and that's intentional.
older qjackctl versions were indeed prone to that layout "dispersion" but recent ones do not go so far unless you already have run the devices on older versions at least once so that they persist in the previous saved location (which was too far from the center long ago).
you can overcome this annoyaince by bringuing/moving back those far away to a close location or you can start from scratch as new installation by removing the configuration file away (~/.config/rncbc.org/QjackCtl.conf; while qjackctl is not running).
hth.
cheers
Copyright (C) 2006-2024 rncbc aka Rui Nuno Capela. All rights reserved.
Powered by Drupal
Recent comments
6 hours 13 min ago
10 hours 43 min ago
10 hours 57 min ago
11 hours 52 min ago
15 hours 21 min ago
20 hours 45 min ago
22 hours 17 min ago
23 hours 46 min ago
1 week 1 day ago
1 week 1 day ago