Add new comment

@Rui: amidi was most certainly 'talking' to the BCF. The Er22 was on the BCF's display, not from amidi. I would get the LED figure 8 pattern for a few seconds, then the Er22. However, the BCF shows up as having 3 separate MIDI ports, and I just chose the first one.

I used amidi -l to show me the ports, and here are the commands I sent, both resulting in the Er22:
amidi -p hw:2,0,0 -s qTractorMixer_1-8.syx
amidi -p hw:2 -s qTractorMixer_1-8.syx

BTW, my BCF is using firmware v1.10.

Lexridge