I was curious how my other hardware generates PC commands and how qtractor detects them. Switching to my workstation showed the same behavior: parameter is always zero, while value changes according to my configured program change. Then I grabbed my midi foot controller with the same results. But both of them send MSB/LSB also. So I am a little lost here, is there any software you can recommend that generates PC commands?
Frank
Copyright (C) 2006-2024 rncbc aka Rui Nuno Capela. All rights reserved.
Powered by Drupal
Recent comments
10 hours 41 min ago
17 hours 58 min ago
2 days 11 hours ago
3 days 2 hours ago
2 days 11 hours ago
3 days 6 hours ago
3 days 17 hours ago
4 days 4 hours ago
4 days 6 hours ago
4 days 7 hours ago