with an "Aux Send" you can route the tapped signal to the internal input of an output bus;
the output of an output bus is a set of JACK output ports, so you may connect them externally to anywhere as long as there are JACK input ports out there; note that routing outputs to outputs makes no sense.
hth.
cheers
Copyright (C) 2006-2024 rncbc aka Rui Nuno Capela. All rights reserved.
Powered by Drupal
Recent comments
1 week 2 days ago
1 week 2 days ago
1 week 5 days ago
2 weeks 4 days ago
2 weeks 4 days ago
2 weeks 6 days ago
3 weeks 3 hours ago
2 weeks 6 days ago
3 weeks 7 hours ago
3 weeks 18 hours ago